I feel this is going to act like wallpaper. Since Modge Podge is generally a glue you could get rid of it like you would any other glue made use of on a wall. You can attempt to steam it initial to loosen the glue and then you can scrape and sand it off. It possibly won’t leave a pretty wall behind so you’ll have to repaint and perhaps even retexture based on your wall. Would it make sense to make your collage on a thin substrate and then mount that to the wall (perhaps with screws)? It would make removal significantly a lot easier at a later date. If you’ve ever removed wallpaper you know it’s not a lot entertaining.
I stumbled across this web page whilst hunting for a distinct product to alleviate my slight damp difficulty and ended up reading all the horror stories posted. While I at present never need to have information and facts I am amazed that no one seems to have thanked ‘Earner’ for all the excellent, impartial (and absolutely free!!) advice given. So, on behalf of absolutely everyone, thank you, Earner.
Holding the border up. A single challenge you will have to have to overcome is how to hold the border in location at the ceiling as you function your way around the room. The finest answer I have come across for this is to hold the border to the wall with a thumb tack, which enables you to come down the ladder to re-position the ladder as you work your way across the wall. The hole left by the thumb tack can be smoothed out with a smoother and should not be noticeable once the border is installed.
i am operating on this ideal now on my staircase in an old residence i just purchased. have been scraping like crazy with a metal putty knife. the progress varies. some regions are very dried out and flake off easily in chunks and other sections are really pretty stubborn… either way it is a lot of function and i will be going in tomorrow to see how a great deal much more i can get rid of. the knife is not gentle on the floors, but i figure I will just sand it out smooth following anyway so I am not worrying also a lot about it. I could just attempt steam on the extra stubborn sections. thanks for the advise!
We had been also very shocked to see how differently the wood paneling responded to the paint than the sheet rock we had been applied to painting. The porous surface of the wood seemed to absorb so a great deal of the paint that it covered much less and appeared a lot additional dull than we expected. Two coats of paint will be vital, at a minimum. Specifically when working with a light colour. And, after applying the very first coat, we decided to go back to the paint shop and buy a gallon of the very same colour but with an eggshell finish for the second coat. A worthwhile investment.